Aquatemp Pool Heaters Manual
aquatemp pool heater manual
If the meter shows voltage, these parts are fine If it does not, replace them Low Flow or Inadequate Heating If your heater shuts off before warming the water to the desired temperature, it may be the result of a dirty filter or an improperly set timer.. Turn off the heater and contact a technician if you cannot find the source of the noise. Click
aquatemp pool heater manual
Begin by checking the safety fuse, then the high limit switch and then the pressure switch.. A dirty filter can prevent the heater from firing Clean the filter and set the temperature switch to the ON position at a high enough setting that the heater turns on.. Touch the other terminal with the other lead A reading of between 20 and 28 volts means the transformer is fine.. OWNERS MANUAL This manual is for Heat Pump Pool Heaters 5005001B Your pool and spa heater combines simplicity with trouble-free performance.. Leave the lead from the voltmeter in contact with the ground or common terminal on the transformer, and check the circuitry connected to the heater as well. HERE
Reset the timer to allow the heater to run for a longer period Check the systems valves as well to make sure that they are turned to go through the heater.. If it is too small, it will not heat properly The pool manufacturers product literature will recommend the right-size heater for your pool.. Check the shut-off valve on gas heaters to ensure that the valve is open and thus supplying fuel to the heater.. If this doesnt resolve the problem, check the transformer by attaching one voltmeter lead to a terminal on the transformer.
If it is lower than that, there may be a problem with the voltage supply or the transformer.. A dirty filter can result in low pressure, and if the pressure leaving the filter is low, this will cause the pressure switch to turn the heater off.. Heater Won't Turn On or Does Not Stay On Clean the filter and turn the thermostat up to try the heater again.. We provide quality products, services, and maintenance for swimming pool heaters.. Inspect the system for blockages and then back-flush the filter A noisy heater can also indicate that it is operating after the pump shuts off, and this is related to a faulty pressure switch that needs to be replaced. 5ebbf469cd 4
The first place to look is your systems hoses and filters Debris can cause the heater to make knocking or whining noises during operation.. If the unit is electric, make sure electrical connections are tight and that there is no corrosion at the terminals. 5
